Advertisement
5
Installing the Switch Panel
to the Sunshade Frame
Parts needed for this procedure:
4
Carriage bolt (#10 x 1/2 inch)
4
Flange locknut (#10)
6
Cable tie
Assembling the Switch Panel to
the Sunshade Frame
1.
Align the square holes in the switch panel with
the square holes in the 2 side-frame channels of
the sunshade as shown in
1. Carriage bolt (#10 x 1/2
inch)
2. Square hole (side-frame
channel)
2.
Assemble the switch panel to the side-frame
channels
(Figure
(#10 x 1/2 inch) and 4 flange locknut (#10).
Figure
8.
Figure 8
3. Square hole (switch panel)
4. Flange locknut (#10)
8) with the 4 carriage bolts
3.
Torque the flange-locknuts to 419 to 513 N∙cm
(37 to 47 in-lb).
Routing the Wire Harness
1.
Route the wire harness of the switch panel kit
along the roll-bar tube as shown in
1. Roll-bar tube
2. Kit wire harness
2.
Secure the wire harness to the roll-bar tube with
the cable ties as needed
6
Installing the Sunshade
No Parts Required
Procedure
1.
Align the holes in the grommets of the sunshade
g245153
with the 4 clipnuts of the side-frame channels.
2.
Assemble the sunshade to the frame channels
(Figure
10) with the 4 flange-head bolts (5/16 x
1-1/4 inches) and 4 washers (5/16 inch) that you
removed in
5
Figure 9
3. Cable ties
(Figure
9).
2 Removing the Sunshade (page
Figure
9.
g245157
2).
Advertisement
