Sony DNW-75 Installation Manual page 14

1-6. Rack Mounting
. Mounting in rack
c
Be sure to carry the unit by the two persons or more.
17. Slide each ball retainer of intermediate rails on both
sides (left and right) in the direction of the arrow.
Ball retainer
18. Pull equal length of each rail both sides out.
19. Lift the unit holding the handles on both sides, slowly
insert the inner rails into the intermediate rails.
20. While pressing each stopper of inner rails on the both
sides (left and right), slowly push the unit into the
rack.
n
Be careful not to catch your finger or hand in rack
mount rail.
Stopper
Inner rail
1-8
Intermediate rail
Intermediate rail
Stopper
21. Slide the unit in and out from the rack about three
times and check that the slide rails move smoothly.
If they are not smoothly, demount the unit and go back
to "Attaching the outer rails" (step 12).
c
When demounting the unit, carry it by the two persons
or more.
n
This unit does not have the feet at this operating.
Put down the unit on the floor or other, being careful
not to damage the unit.
22. Secure the unit to the rack with two screws and two
ornamental washers.
Tightening torque: 120 x 10
Ornamental washer
RK5 x 14
RK5 x 14
_2 N . m {12.2 kgf . cm}
Ornamental washer
DNW-75/75P
DNW-65/65P