The Input Setting Menu - Sony S1800Q Operating Instructions Manual

The INPUT SETTING Menu

The INPUT SETTING menu is used for adjusting the
input signal.
Adjustable items are displayed in green.
The INPUT SETTING menu consists of two pages.
To change the page, press the V or v key until the page
changes when selecting an item.
On the Remote Commander, move the joy stick up or
down until the page changes when selecting an item.
<Page 1>
I NPUT S E T T N G I
DOT PHASE : 4
INPUT
SELECT
DOT CLOCK : 1 2 3
S H F T I H : 1 2 3 V 1 2 3 :
PICTURE
CTRL
CLAMP : AUTO
F L T E R I : O F F
INPUT
SETTING
SYNC SEL : AUTO
COLOR TEMP : 6 5 0 0
SET
SETTING
RESET:
MEMORY: MEMORY RESET
INPUT
INFO
SEL: SET: / EXIT:
ENTER MENU
<Page 2>
I N P U T S E T T N G I
SCAN CONV : ON
INPUT
SELECT
BLKG : O N
PICTURE
CTRL
INPUT
SETTING
SET
SETTING
MEMORY: MEMORY RESET: RESET
INPUT
INFO
SEL: SET: / ENTER EXIT: MENU
Note
Depending on the input signal, page 2 may not be
displayed.
Operation
1
Press the MENU key.
The menu display appears.
The menu presently selected is highlighted in blue.
2
Select the INPUT SETTING menu using the V or
v key on the control panel, then press the b or
ENTER key.
On the Remote Commander, move the joy stick up
or down to select the INPUT SETTING menu,
then move it to the right or press the ENTER key.
Now you can select the item in the menu.
3
Select an item using the V or v key on the control
panel, then press the b or ENTER key.
On the Remote Commander, move the joy stick up
or down to select an item, then move it to the right
or press the ENTER key.
..........................................................................................................................................................................................................
1) DMD TM is a trademark of Texas Instruments Incorporated, U.S.A.
4
Make adjustment or setting on the selected item.
When changing the adjustment level:
To increase the value, press the V or b key.
On the Remote Commander, move the joy stick up
or to the right.
To decrease the value, press the v or B key.
On the Remote Commander, move the joy stick
down or to the left.
To enter the value and return to the previous
screen, press the ENTER key.
When changing the setting:
Use the V or v key on the control panel to change
the setting, then press the B or ENTER key.
On the Remote Commander, move the joy stick up
or down to change the setting, then move it to the
left or press the ENTER key.
The previous screen is restored.
5
Press the MEMORY key on either the control
panel or the supplied Remote Commander after
adjustment or setting.
DOT PHASE
Adjusts the dot phase to fit picture pixel of the input
TM 1)
signal to that of DMD
Adjust the setting level to obtain the sharpest picture.
DOT PHASE : 4
DOT CLOCK
Adjusts the horizontal length of the picture.
DOT C L O C K : 1 2 3
.
(Continued)
23
(EN)