Toro Groundsmaster 360 Installation Instructions page 2

2
Installing the Differential Lock
Kit
Parts needed for this procedure:
1 Mount plate
2 Carriage screw (3/8 x 1 inch)
2 Flange nut (3/8 inch)
1 90° fitting
1 Differential lock valve
2 Screw (1/4 x 2 inches)
2 Flange nut (1/4 inch)
1 Hose
Procedure
1. Release and raise the seat. Make sure that the seat latch
is engaged.
2. Install the mount plate to the frame cross member with
2 screws (3/8 x 1 inch) and 2 nuts (3/8 inch). Position
the plate as shown in
Note: Make sure that the O-rings are in place and
lubricated with hydraulic fluid.
3. Install the 90° adapter fitting into the end of the
differential lock valve, positioning as shown in
4. Install the differential-lock valve to the mount plate
with 2 screws (1/4 x 2 inch) and 2 nuts (1/4 inch).
Position the differential-lock valve on the mount plate
as shown in Figure
Figure 1.
1.
1. Frame member
2. Mount plate
3. Differential-lock valve
4. Nut (1/4 inch)
5. Disconnect the hose, shown in
fitting on the right side of the transmission.
6. Install the disconnected end of the hose to the 90°
adapter fitting on the differential-lock valve and tighten
Figure 1.
it securely
7. Install the male end of the new hose to the port in the
differential lock valve and tighten securely
2
Figure 1
5. 90° adapter fitting
6. Nut (3/8 inch)
7. Screw (1/4 x 2 inches)
8. Screw (3/8 x 1 inch)
Figure
(Figure 2).
2, from the 90°
(Figure 2).