Toro Groundsmaster 360 Installation Instructions page 3

8. Install the female end of the new hose to the 90° fitting
on the right side of the transmission
Figure 2
1. Disconnect the hose here.
2. Connect the hose here.
(Figure 2).
3. Connect the male end of
the new hose here.
4. Connect the female end of
the new hose here.
3
Installing the Switch
Parts needed for this procedure:
1 Switch
1 Wire harness
Procedure
1. Remove the plug from the control panel to expose the
switch-mounting hole
2. Insert the switch into the control-panel hole
Position the switch so that you press it forward.
1. Plug
2. Switch
3. Remove the 5 button-head screws securing the control
panel to the tank cover.
4. Raise the panel and plug the harness connector on the
new wire harness into the switch.
5. Route the wire harness under the control panel and
seat plate as shown in
3
(Figure 3).
(Figure
Figure 3
3. Harness
Figure 4.
3).