Yamaha RIVAGE PM3 CS-R3 Owner's Manual page 18

1
6
7
8
9
)
!
@
#
1
18 CS-R3 Owner's Manual
A B
A B
6 Strip encoder
You can use both the Screen Encoder function and
the Channel Encoder function for channel strips
1–12 on bay C. Use the [ENCODER ASSIGN] key
(see 1 on page 17) to toggle between these two
functions. You can use only the Channel Encoder
function for channel strips 1–12 and channel strips
A/B on bay L and bay R.
• Screen Encoder function:
Up to 12 parameters can be assigned by selecting
controls on the screen.
• Channel Encoder function:
Parameters for 12 channels on the channel strips
can be assigned. Use the [ENCODER ASSIGN]
key (see 1 on page 17) to toggle between these
two functions.
7 [SEL] key
Enables you to select the channel that will be
controlled in the Channel Strip section or on the
display. When the channel is selected, the key LED
will light.
8 [CUE] key
Selects the channel for cue.
9 Meter LEDs
Indicate the channel level.
) [ON] key
Switches the channel on or off. If the channel is on,
the key LED will light. If the channel is in a mute
group, the key indicator will flash. In SENDS ON
FADER mode (see 5 [SENDS ON FADER] key on
page 17), this key works as an on/off switch for
signals sent from each channel to the currently-
selected MIX/MATRIX bus.
! Channel name display
Indicates the channel name, fader value, etc.
@ Channel color indicator
Indicates the channel color.
# Fader
This is a touch-sensitive 100 mm motorized fader. In
SENDS ON FADER mode, this fader adjusts the send
level of the signal sent from each channel to the
currently-selected MIX/MATRIX bus.