Rear Panel - Yamaha RIVAGE PM3 CS-R3 Owner's Manual

Rear panel

6
7
1 LAMP jacks
These four 4-pin female XLR output jacks are used to
supply power to optional Yamaha LA1L gooseneck
lamps.
2 MIDI OUT/IN jacks
These jacks are used to transmit/receive MIDI
messages to/from external MIDI devices.
3 GPI connector
This is a D-sub 25-pin female connector that allows
communication (8-in, 8-out) with a GPI-equipped
external device.
4 [FAN] switch
Sets the internal cooling fan to operate at either
HIGH or LOW speed.
NOTE
This switch is set to LOW when the unit is initially shipped
from the factory. As long as the unit is operated within the
specified ambient temperature range either the LOW or
HIGH setting can be used. The HIGH setting is
recommended if the ambient temperature is high, if the unit
is in direct sunlight even if the ambient temperature is
within the specified operating range, and in any situation in
which fan noise is not a problem.
5 [RESET] switch
Resets the control surface.
Only the controls (screens, indicators, and control
keys and knobs) on the control surface will restart
without interrupting audio. Use this switch in case
the control surface becomes non-responsive to your
operations.
1
8 2
9
)
@
! #
1
3 4
^
$
%
6 OMNI IN jacks
These are balanced XLR-3-31 female input jacks for
inputting analog audio signals from line level devices
or microphones.
Male XLR plug
7 OMNI OUT jacks
These are balanced XLR-3-32 male output jacks that
transmit analog audio signals.
Female XLR plug
8 USB ports
Use these ports to connect a USB storage device such
as a flash drive, USB mouse, or USB keyboard.
9 MY card slots
Install optional Mini-YGDAI I/O cards here to
expand I/O ports.
5
*
&
1 (Ground)
3 (Cold)
2 (Hot)
2 (Hot)
3 (Cold)
1 (Ground)
CS-R3 Owner's Manual 21