Table of Contents
Advertisement
Thermal Mapping
1.
Thermal Mapping overlays the visible and thermal videos to synchronize the data coming from
the two separate lenses, corresponding to how accurate the temperature detection results will be.
2.
The goal of Thermal Mapping is to have the green square on the visible camera view match up with
the green square on the thermal camera view that was set in thermal calibration.
3.
Use zoom and focus controls found in the red box above to best match the zoom of the thermal
camera view on the right side.
4.
Select a Mapping Point. There are three possible points. The more points you calibrate the more
accurate your mapping will be. Match the same color points on the thermal camera view to the
visible camera view.
5.
The green box will calibrate itself on the visible camera view based on the Mapping Points on both
thermal and visible camera views.
Note: The closer the green square is to exactly outlining the Blackbody, the more accurate your results
will be.
DCS-9500T Quick Installation Guide
7
Advertisement
Table of Contents
