Sharp AN-52AG6 Operation Manual page 24

Setting the Angle of the Wall-mount Brackets
• When adjusting the wall-mount bracket angle, make sure not to pinch your finger or
3
Caution
• Make sure the angle setting pieces are inserted all the way into the grooves and that
Matching the angle being set
Insert the bolts into the grooves for the desired angle setting marks and use a screwdriver or
hex spanner wrench to tighten them.
0
0
5
10
15
20
Tighten the angle holding screws
4
Use the 2 angle holding screws (M5, 8mm length) removed in Step 1 to set the angle.
The angle holding screws are not used when the angle is set to 20 , so store the screws
where they will not be lost.
(Example: When set to 15 .)
E-10
something else.
the angle setting screws are sufficiently tightened. If the angle setting screws are not
inserted all the way into the grooves or if they are not sufficiently tightened, the
television could fall off of the wall.
5
0
5
10
15
20
10 15
0
0
5 5
10
10
15
15
20
20
(Continued)
20
0
5
10
15
20
Angle holding
screw hole for 15