Board Configuration - Fsr3-Sir (Fd8601-Current) - Bosch FSR Series Training Manual

Board Configuration – FSR3/SIR (FD8601 – Current)
The keypad interface for the control is located on the glass panel. The control display board is
mounted behind. Communications between the display board and the power board automatically
configure the control for gas or electric range and if it is an FSR3 or SIR.
Service Configuration Mode is accessed only when the unit is plugged in (that is, the unit is unplugged,
and then plugged back in) and the display shows CLOCK and the 12 is flashing. Once [Off] is
pressed, OR the knob is rotated, system configuration access is denied.
READ THROUGH THESE STEPS BEFORE STARTING MODEL CONFIGURATION (these
instructions are also included with the board)
1. Switch to the set clock mode.
2. Simultaneously press [Light] and [Temperature] (or [Broil] if the model number begins with 30)
and hold for 5 seconds.
3. After 5 seconds the display shows SYSTEM CONFIG and beeps once.
4. You have 10 seconds to select [Start] or the control automatically returns to operation.
5. When [Start] is pressed the display changes to SET SYSTEM and beeps once.
6. Starting immediately you have 10 seconds to rotate the knob to select a model or the control will
automatically return to operation. See below for model number and description.
Jan. 2008, Iss. 1
42