Unpack And Set Up; Operation - Silvercrest STV 45 B1 Operating Instructions Manual

RP86188 Tower-Ventilator LB4 Seite 6 Freitag, 11. Januar 2013 3:04 15
• Ensure that the packing foil does not
become a deadly trap for a child.
Packing foils are not toys.
5.1 Assemble appliance
Before the appliance can be started up,
stand 8 needs to be screwed on.
1. Take the appliance
packaging.
2. Remove the transport packaging.
3. Check that the appliance has not
sustained any damage.
4. Put rear half of the stand 10 and front
half of the stand 11 together.
Note You can recognize rear half of the
stand 10 by the depression for power
supply cable 9.
5. Use screw ring 12 supplied to screw
stand 8 to the underside of the tower
fan.
Notes
– On delivery, screw ring 12 is screwed
onto the bottom of the tower fan.
6.1 Start and switch off the appliance
1. Plug the power plug into a power supply
socket which meets the technical data
requirements (see "3. Technical data"
on page 4).
6

5. Unpack and set up

– Ensure that power supply cable 9 is
located in the depression provided for it.
– Tighten screw ring 12 hand-tight. Do
not use a tool.
out of the
6. Select a location in line with the safety
instructions (see "4. Safety instructions"
on page 4).
7. Plug the power plug into a power supply
socket which meets the technical data
requirements.

6. Operation

2. Switch on the power
supply by turning rotary
switch 2 to "ON".
The appliance is now operational.