Cleaning - Silvercrest STV 45 B1 Operating Instructions Manual

RP86188 Tower-Ventilator LB4 Seite 7 Freitag, 11. Januar 2013 3:04 15
3. Switch off the power
supply by turning rotary
switch 2 to "OFF".
6.2 Set blower setting
The blower settings are used to select how
fast the appliance circulates air in the room.
The appliance has three blower settings:
– 1, low: press button 6;
– 2, moderate: press button 4;
– 3, high: press button 3.
Press the 7 "OFF" button to stop the
appliance working.
6.3 Set running time
The appliance has a timer which you can
use to set the desired running time to
between 0 and 120 minutes.
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
with a vacuum cleaner.
2. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
STV 45 B1
1. Switch on the timer by
turning rotary switch 2 to
any time between 0 and
120 minutes. The power
supply is switched on at
the same time.
2. To switch off the timer, set rotary
switch 2 to "OFF".
Note If you want the appliance to operate
continuously, set rotary switch 2 to "ON".
6.4 Oscillation function
The appliance has an oscillation function.
This causes the appliance to move to and
fro, distributing the air produced evenly
throughout the room.
1. Switch on the oscillation function by
pressing oscillation function key 5.
2. Switch off the oscillation function by
pressing oscillation function key 5 again.

7. Cleaning

Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
3. Wipe the appliance with a cloth
moistened with clear water.
4. Do not use the appliance again until it
has dried completely.
7