Yamaha MTX Series Setup Manual page 140

 OUTPUT settings
In OUTPUT you can make the following settings.
Port select button
Port / External
Device parameter
access button
DELAY / Room EQ
Speaker processor
[ON] button
Fader
Channel name
Port select button
Click this to open the "Output Patch" dialog box. For this example, apply the fol-
lowing changes. After making the settings, click the [Close] button.
CH1 through CH8
CH9 through CH16
Port / External Device parameter access button
When you click this button, the MTX output jack parameter edit screen will
appear as a popup.
DELAY / Room EQ
Click this to move to a screen where you can set delay and room EQ.
Speaker processor
Click this to switch to the "CHANNEL EDIT" screen. Make the appropriate set-
tings for the speakers that will be connected.
NOTE
The pre-installed library contains speaker processor files that are appropriate for the
response of various speakers. By using these files you can make speaker processor set-
tings easily.
[ON] button
This button turns the channel on/off. Turn off unused channels.
Fader
This adjusts the output level.
Channel name
You can double-click this to edit the name.
In this example, names have been assigned as follows.
OUT1
OUT2
OUT3
OUT4
OUT5
OUT6
OUT7
OUT8
Example 5) A system using the PGM1 for paging
DANTE 1 through DANTE 8
No assignment (click an assigned button to specify no
assignment)
Luxury
Casual1
Casual2
Casual3
Event Space
Food Court
Entrance
Restrooms
140
MTX Setup Manual