Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for DeWalt DCM572
Summary of Contents for DeWalt DCM572
- Page 1 DCM572...
- Page 2 English (original instructions) Copyright D WALT...
- Page 3 Figure A Figure B Figure C Figure D...
- Page 4 Figure E Figure F Figure G Figure H Figure I Figure J...
-
Page 5: Technical Data
English HANDHELD BLOWER DCM572 Congratulations! The vibration emission level given in this information sheet has been measured in accordance with a standardised test You have chosen a D WALT tool. Years of experience, given in EN50636 and may be used to compare one tool thorough product development and innovation make with another. -
Page 6: Handheld Blower
Handheld Blower fire, electric shock, personal injury and material damage. DCM572 • Read all of this manual carefully before using the WALT declares that these products described under... -
Page 7: Electrical Safety
English After Use non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. • When not in use, the appliance should be stored in a dry, • Prevent unintentional starting. Make sure that the switch is in well ventilated place out of the reach of children. -
Page 8: Using An Extension Cable
English Electrical Safety • Do not place your unit down on gravel while it is switched on. • Always be sure of your footing, particularly on slopes. Do The electric motor has been designed for one voltage only. not overreach and keep your balance at all times. Always check that the battery pack voltage corresponds to •... -
Page 9: Charger Operation
English CAUTION: Burn hazard. To reduce the risk of injury, Disconnect the charger from the outlet before • charge only D WALT rechargeable batteries. Other attempting any cleaning. This will reduce the risk of types of batteries may burst causing personal injury electric shock. -
Page 10: Wall Mounting
English liquids, gases or dust. Inserting or removing the battery A cold battery pack will charge at a slower rate than a warm battery pack. The battery pack will charge at that slower rate from the charger may ignite the dust or fumes. throughout the entire charging cycle and will not return to •... -
Page 11: Storage Recommendations
English terminals are protected and well insulated from materials pack from certain shipping regulations that are imposed that could contact them and cause a short circuit. D WALT upon the higher Watt hour batteries. batteries comply with all applicable shipping regulations as For example, the Example of Use and Transport Label Marking prescribed by industry and legal standards which include UN... -
Page 12: Battery Type
) which also includes the year of 18 manufacture, is printed into the housing. Battery Type Example: The DCM572 operates on a 54 volt battery pack. 2016 XX XX These battery packs may be used: DCB546, DCB547. Refer to Year of Manufacture Technical Data for more information. - Page 13 English 2. Slide the nozzle onto the tube. WARNING: Use only D WALT battery packs and chargers. 3. Firmly twist the nozzle to lock the nubs completely into the recess of the nozzle. Ensure the nozzle is securely attached. Inserting and Removing the Battery Pack OPERATION from the Tool (Fig.
-
Page 14: Protecting The Environment
English Australia & New Zealand Stanley Black & Decker Lubrication www.blackanddecker.com.au Your power tool requires no additional lubrication. www.blackanddecker.co.nz Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ) Cleaning WARNING: Blow dirt and dust out of the main housing with dry air as often as dirt is seen collecting in and around the air vents.