Advertisement
Installing Cables for the Maintenance Compartment
12.2
Cable Hole Diameter Requirements
Installation Procedure
1. Push up the sunshade
until the spring fastener
is stuck gently.
4. Install the bullet camera
power cables.
Cable distribution terminal
Bullet camera 3
2. Open the maintenance
compartment.
Use waterproof tape to protect
the cable distribution terminal
and put it inside the pole.
Bullet camera 1
Bullet camera 2
Cable Hole
No.
Silk Screen
RS485 or FE communications
1
GE
RS485 or FE communications
2
RS485/FE
3
DI
Network device power cable
4
DO
Dome camera alarm linkage cable
5
12VDC
Bullet camera power cable
6
24VAC
Dome camera power cable
3. Install the dome camera power cable.
5. Install the NetEco cable.
9
Cable Outer
Cable Type
Diameter
cable
6.8±0.3 mm
cable
9.3±0.4 mm
NOTE
The power cable for the
dome camera can only
be connected to the
24VAC port.
Dome camera
Network
device
Advertisement
