ABB ACS800 Series Hardware Manual page 75

Frame sizes R6: Cable lug installation [16 to 70 mm
PE
6
5
Frame size R6: Screw terminal installation [95 to 210 mm
PE
6
5
2
(6 to 2/0 AWG) cables]
Remove the screw terminals. Fasten the cable lugs
to the remaining bolts with M10 nuts.
Isolate the ends of
the cable lugs with
insulating tape or
shrink tubing.
Shroud on the conductor terminals (screw
terminal installation)
5
2
b
a. Connect the cable to the terminal.
b. Connect the terminal to the drive.
5
9
(3/0 to 400 MCM)] cables
a
WARNING! If the wire size is less than
2
95 mm (3/0 AWG), a cable lug must
be used. A cable of wire size less than
2
95 mm (3/0 AWG) connected to this
terminal will loosen and may damage
the drive.
Electrical installation
75
9