Lifting The Machine - Toro TX 525 Operator's Manual

1. Tie-down loops
Unloading the Machine
1. Lower the ramp(s).
2. Unload the machine from the trailer with the
heavy end up the ramp, carrying loads low
(Figure 22).
•
If the machine has a full load-bearing
attachment (e.g., bucket) or a
non-load-bearing attachment (e.g.,
trencher), back it down the ramp.
•
If the machine has an empty load-bearing
attachment or no attachment, drive it forward
down the ramp.
1. Machine with full
attachment or
non-load-bearing
attachment—back the
machine down the
ramp(s).

Lifting the Machine

You can lift the machine using the tie-down/lift loops
as lift points; refer to Figure
Figure 21
Figure 22
2. Machine with empty or
no attachment—drive the
machine forward down the
ramp(s).
21.
g243576
g317100
21