Toro 22324 Setup Instructions

TX 525 Compact Tool Carrier
Model No. 22323—Serial No. 316000001 and Up
Model No. 22323G—Serial No. 316000001 and Up
Model No. 22324—Serial No. 316000001 and Up
This product contains a chemical or chemicals known to the State of California to
Charging the Battery
1. Open the rear access cover.
2. Connect a charger to the battery
it for a minimum of 1 hour at 6 to 10 amps.
Note: Do not overcharge the battery
4
2
1. Positive post
2. Negative post
3. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
4. Close the rear access cover.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
(Figure 1) and charge
3
1
G003792
Figure 1
3. Charger red (+) wire
4. Charger black (–) wire
(Figure 1).
Register at www.Toro.com.
WARNING
CALIFORNIA
Checking the Fluid Levels
Before starting the engine for the first time, check the engine
oil and hydraulic fluid levels. Refer to the Operator's Manual
for more information.
Setting the Engine RPM (CE
Only)
If you are setting up this machine for use in the European
Community, you need to permanently adjust the engine speed
so that it does not run above 3200 RPM, as follows:
1. Start the engine and run it at half throttle for 5 to 10
minutes to warm it up.
Important: The engine must be warm before
making this adjustment.
2. Move the throttle lever to the Fast position.
3. Check the engine speed using a tachometer. It should
be around 3600 RPM.
4. Loosen the jam nut securing the high idle adjusting
screw on the engine (located on the throttle cable
support
Form No. 3403-187 Rev A
Setup Instructions
bracket—Figure 2).
Original Instructions (EN) All Rights Reserved *3403-187* A
Printed in the USA