Toro 22324 Setup Instructions page 2

1
2
3
1. High idle adjusting screw
2. Jam nut
5. Turn the high idle adjusting screw inward to lower the
RPM to between 3100 and 3200 RPM.
Important: If you exceed 3200 RPM, the engine
will not be in compliance with CE regulations and
cannot be legally sold or used in the European
Community.
6. Secure the screw with the jam nut, checking the engine
RPM again as you do so.
7. Slide the small aluminum tube over the high idle
adjusting screw and jam nut.
8. Crimp the tube down to the screw shaft with a pliers
between the screw head and the jam nut so that the jam
nut cannot be loosened in the future.
Important: The tube must be fully over the jam
nut to prevent access to it.
Installing the Production Year
Decal (CE Only)
If you are setting up this machine for use in the European
Community, you need to add the production year decal,
found in the loose parts bag, to the machine. Install the decal
just above the serial plate on the machine, following the
instructions provided on the decal.
Figure 2
3. Throttle cable support
bracket
G009727
2