Related Manuals for Toro 03217
Summary of Contents for Toro 03217
- Page 1 Form No. 3325–354 27” Verticutting Reel Reelmaster 3100-D Attachment Model No. 03217—Serial No. 220000001 and Up Operator’s Manual English (EN)
-
Page 2: Table Of Contents
Authorized Service Replace Center Cutting Unit Pivot Pin ..Dealer or Toro Customer Service and have the model and serial numbers of your product ready. The model and serial Leveling Front Roller . -
Page 3: Safety
To ensure optimum performance and safety, always unit is in safe operating condition. purchase genuine Toro replacement parts and accessories to keep the Toro all TORO. Never use Always wear substantial shoes. Do not operate “will-fit” replacement parts and accessories made by verticutting units while wearing sandals, tennis shoes, other manufacturers. -
Page 4: Specifications
For use on Reelmaster 3100 traction units with Spacer serial numbers of 210000001 or lower O–ring For use with reel motor bearing housing CE Decal Affix to cutting unit for CE. Operator’s manual Read before operating. Parts catalog Registration Card Fill out and return to Toro... -
Page 5: Setup
Setup 2. Rock verticutting reel on blades, so front roller touches level surface. If a gap between front roller and surface is greater than .010” (.25mm), proceed as follows: Note: Determine the left and right sides of the machine Loosen the lock nuts securing the front roller brackets from the normal operating position. -
Page 6: Adjust Front And Rear Grass Shields
Adjust Front and Rear Grass Shields Note: When operating in turf conditions where much debris is encountered, or unusually heavy thatch, open the front and rear discharge shields to help allow the debris to discharge from the reel. 1. Loosen the capscrews on the pivot of the grass shield. 2. -
Page 7: Operation
Operation 3. Power requirements to operate the verticutting reels will vary with turf and soil conditions. Travel speed may need to be reduced in some conditions. 4. When operating in turf conditions where much debris is Training Period encountered, or unusually heavy thatch, open the front and rear discharge shields to help allow the debris to Before operating the verticutting reels, evaluate the discharge from the reel. -
Page 8: Maintenance
Maintenance .188 in. dia. (2) .625 in. dia. Lubrication .625 in. Each unit has (3) grease fittings that must be lubricated .625 in. regularly with No. 2 General Purpose Lithium Base Grease. 1/4–20 UNC (2) 1. The grease fitting locations and quantities are: reel bearings (2) and carrier frame (1). -
Page 9: Removing Verticutting Reel
2. Loosely secure roller assembly in bench vise and lightly tap one end of roller shaft until free from housing. 3. Remove second bearing from shaft. Support bearing on inner race and tap on roller shaft. 4. Inspect bearings, shaft, and snap ring for damage. Replace damaged components. -
Page 10: Install Verticutting Blades
Important Do not invert verticutting reel blades. The order of disassembly is extremely important. Do not invert verticutting reel blades when disassembling .57 .03 or reverse the order when assembling. Note the verticutting blades index hole. The index hole is provided for assembly in order to obtain the proper helix for the verticutting reel. -
Page 12: The Toro General Commercial Products Warranty
If for any reason you are dissatisfied with your Distributor’s service or have difficulty obtaining guarantee information, contact the Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company.