Installing The Pbbu; Harness Cable Clamp; Pbbu Mounting Bracket; Mpsa Control Panel - Toshiba Strata VI Installation Instructions Manual

SECTION 100-006-250
MPSA-200 ;NSTALLATION
DECEMBER 1982
FIGURE lZ
02.20 Installing the PBBU
02.21 Mounted in the M PSA control
panel are two hole plugs, remove and
discard them.
02.22 Unwrap the PBBU.
and save the screw locn.tcd
mounting brncket (Pigure 13).
FIGURE 13
llernove
in
the
02.23 Slip the PBBU fuse holder and
battery override button through their
respective ports in the control panel
(Figure 14). The PBBU mounting brac-
ket should be flush against the rear of
the control panel. The harness should
flow around the PI3BU PCB, with no
wires beneath
it.
-6-
FIGURE 14
02.2-<i Align the two tan-colored
PBBU pins with the two holes in the
mounting bracket (Figure 15). Press
the pins into the holes until they catch.
FIGURE 15
02.25 Use the previously removed
screw and secure the mounting bracket
to the control panel (Figure 14).
02.26 Plug the connector into the
nine-hole jack in the center of the
PBBU. Do not force the prongs into
the jack, they are keyed so that they
can be mated in only one position.
02.27
from
the
Make certain that no wires
the harness are caught between
cover and the PBBU heat sink