Installation Finalization - Toshiba Strata VI Installation Instructions Manual

SECTION 100-006-250
MPSA-200 INSTALLATION
DECEMBER 1982
Battery
#
2
Single-Wire
Cable
+ Marker
- Marker
Battery Rack
and Separator
Clamp
EPSA-104
2-W ire
To MKSU
FlGURE 18
02.46
Attach the negative wire of
the 2-wire cable to the battery fuse
(or circuit breaker).
02.47 Connect the positive wire to
the positive terminal of battery
#
2 (see
Figure 17).
02.48 Connect the two batteries
with the single-wire cable-one end to
the positive terminal on battery #1 and
the other end to the negative terminal
on battery #2 (Figure 18).
NOTE:
Place the cable clamp over
the two-wire cable and secure
it to either the battery rack
or
the protective cabinet.
Adjust the clamp to relieve
strain on the cable.
-B-
02.50 Installation Finalization
02.51 Plug the AC power cord in,
and verify that the AC ON indicator is
lit.
02.52 Unplug the AC power cord,
and verify that the DC ON indicator is
lit to indicate the batteries are sup-
plying electrical power.
02.53 Replace the terminal strip
cover and test the STRATA VI system
functions under both AC and battery
back-up power.
CAUTION:
When testing is complete,
make certain that the battery
override button is in the OFF
position and that the AC ON
indicator is lit.