Motorola Symbol STB20 Series Quick Reference Manual page 3

Quick Reference Guide
Introduction
The Symbol STB20XX cordless scanner cradles act as chargers and host
communication interfaces for the Symbol MT2000 Series cordless scanners.
Cradles can sit on a desktop, mount on a wall or mount on a forklift (STB2000-F
only). This document provides basic instructions for cradle set up and use. Unless
otherwise noted, "cradle" refers to all configurations of the single slot cradle. Any
discussion of transmission of information refers specifically to cradles with
Bluetooth technology.
Configurations
Cradle Configuration
STB2000
STB2078
STB2000-F
Accessories
The following equipment may be needed:
For the STB2000/STB2978 cradle:
Three 1.5" #8
• ???
available from Motorola).
Power supply for desk/wall mounting configuration (p/n 50-14000-239R).
•
???
For the STB2000-F cradle:
• Mounting bracket
• 9 Vdc, minimum 2A power supply for forklift configuration (p/n 50-14000-122R)
???
Three 1/4-20 ???
•
.
bracket
• Four 1/4-20 ??? screws, minimum length 1.0 in., for fastening bracket to
DRAFT mounting surface
Description
Single slot, charge only.
Charge only cradles can communicate with a PC via
ActiveSync by attaching a USB cable to the USB
connector (see Connections on page
Single slot, multi-interface with Bluetooth technology.
Bluetooth cradles receive data from the scanner via a
Bluetooth radio and send the data to the host through an
attached cable (see Connections on page
Forklift single slot, charge only
Phillips head screws for wall mounting, if applicable (not
???
screws, minimum length 1.0 in., for fastening the cradle to the
(not available from Motorola).???
3
7).
7).