Changing The Host Interface - Motorola Symbol STB20 Series Quick Reference Manual

Quick Reference Guide
Connections
IMPORTANT
Connect the USB/host interface cable and power supply (if
necessary) in the order of the steps below to ensure proper
operation of the scanner and cradle.
Connections vary by cradle configuration. The STB2000 and STB2000-F cradles
are charge only cradles. The host interface port can only be used to connect a
USB cable to a PC for an ActiveSync connection.
Insert the USB or host interface cable into the cradle's USB/host port.
1.
Connect the other end of the cable to the PC.
2.
Connect the appropriate cable to the power supply and an AC power source, if
3.
necessary.
Optional: Thread the USB/host interface cable over the cable support hook and
4.
run the host and power cables into their respective cable grooves.
For forklift cradles, if cables are not thread into their respective cable grooves,
it is recommended to use cable ties to secure cables to the mounting plate
after it is attached to the cradle (see
If necessary, scan the appropriate host bar code (for non-autodetected
5.
interfaces).
For Bluetooth cradles, scan the Pairing bar code on the cradle. Refer to the
6.
User Guide.

Changing the Host Interface

To connect to a different host, or to the same host through a different cable:
Unplug the power supply from the cradle.
1.
Unplug the interface cable from the host.
2.
DRAFT
Connect the interface cable to the new host, or the new interface cable to the
3.
existing host.
Power Port
USB/Host Port
Mounting the STB2000-F on the
7
Forklift).