Toro TX 427 Operator's Manual page 24

Opening the Rear-Access Cover
1. Unscrew the 2 hand knobs securing the
rear-access cover to the machine
Figure 25
1. Hand knobs
2. Tilt the rear-access cover down and remove it to
access the internal components
Closing the Rear-Access Cover
1. Move the rear-access cover in place over the
back of the machine; ensure that the tabs line
up in the slots.
2. Push the access cover forward, lining up the
hand-knob screws with the threaded holes in
the machine.
3. Screw the hand knobs tight to secure the
rear-access cover in place.
Removing the Side Screens
1. Open the hood.
2. Slide the side screens
the slots in the front screen and frame.
Figure 26
1. Side screen
(Figure 25).
g004185
(Figure 25).
(Figure 26) up and out of
g004186
Installing the Side Screens
Slide the side screens into place in the slots in the
front screen and frame.
Removing the Front Screen
CAUTION
If the engine has been running, the heat shield
will be very hot and could burn you.
Allow the machine to cool completely before
touching the heat shield.
1. Open the hood and remove both side screens.
2. Loosen the bolts securing the weights
27).
1. Front weight
2. Bolts
3. Sloped plate
3. Remove the carriage bolts and nuts securing the
sloped plate (Figure
4. Lift the sloped plate up and off the machine.
5. Remove the 4 bolts securing the front screen to
the frame (Figure
24
(Figure
Figure 27
4. Carriage bolts
5. Rear weight
27).
28).
g013122