Purifi Er; Dust Sensor - Hitachi EP-PF120J Instruction Manual

Cleaning
Purifi er
(Guide for Cleaning: About Once a Month)
 Wipe off dirt on the unit, touch operation panel and the surface using a soft, damp cloth.
 Clean adhering chemicals such as oil components and insecticides regularly.
 Remove dust from the surfaces of the front panel air inlet, dust sensor, odor sensor and using
a vacuum cleaner and wipe off using a soft cloth.
Remove the front panel when cleaning the odor sensor.
 Do not clean only the front side of the front panel, but detach it from the unit and clean the
back side as well.
Front panel (Air inlet)
Nozzle brush

Dust Sensor

 Clean regularly at least once every 3-6 months.
The dust sensor is less likely to detect dirt in the air if it is not cleaned regularly.
If the sensor is dirty, it might not work properly and will detect dust even if the air is clean.
Check if the operation has stopped before
1
removing the power plug from the socket
 While operating, touch the
stop operation.
Remove dust sensor cover and collect
2
the dust
 Place your finger on the lower part and press.
 Remove the dust cover, vacuum well using the nozzle
brush of the vacuum cleaner, and wipe using a soft cloth.
E-28
EP-PF120J_EN.indd 28 EP-PF120J_EN.indd 28
(Continued)
Dust sensor
(Guide for Cleaning: At Least Once Every 3-6 Months)
power button and
Dust sensor cover
Nozzle brush
(P.E-14)
Odor sensor
3
Wipe the lens with a cotton swab
(commercial product)
 When dirt is difficult to remove, wipe the lens
with a cotton swab slightly moistened with
water, then wipe with a dry cotton swab after.
 Remove all dust around the lens.
 After cleaning, attach the dust sensor cover.
 After cleaning, plug the air purifier in a clean
environment and turn on in Auto mode. If the
Clean Monitor does not turn blue after about
10 minutes, there might be remaining dust left.
Please clean it again.
CAUTION
 Do not put excessive force on the lens.
This may cause damage.
 Do not use excessive force when removing and
attaching the tabs of the dust sensor cover.
This may cause damage.
Lens
2/11/2019 3:36:29 PM 2/11/2019 3:36:29 PM