1. Manuals
  2. Brands
  3. Husqvarna Manuals
  4. Trimmer
  5. 520iLX
  6. Operator's manual

Husqvarna 520iLX Operator's Manual

Hide thumbs Also See for 520iLX:
Table of Contents

Advertisement

Quick Links

520iLX
EN
Operator's manual
2-26

Advertisement

Table of Contents
loading

Related Manuals for Husqvarna 520iLX

Summary of Contents for Husqvarna 520iLX

  • Page 1 520iLX Operator's manual 2-26...

  • Page 2: Table Of Contents

    EC Declaration of Conformity........26 Introduction Product description Intended use Husqvarna 520iLX is a battery grass trimmer with an The product is used with a trimmer head to cut grass. electrical motor. Do not use the product for other tasks than grass trimming and grass clearing.
  • Page 3 7. Power trigger lockout Symbols on the product or its packaging 8. Battery indicate that this product cannot be handled 9. Cord as domestic waste. This product must be deposited at an appropriate recycling facility. 10. Battery charger 11. Operator's manual 12.

  • Page 4: Safety

    • the product is incorrectly repaired. • the product is repaired with parts that are not from the manufacturer or not approved by the Double insulation. manufacturer. • the product has an accessory that is not from the Product liability manufacturer or not approved by the manufacturer.
  • Page 5 that could be thrown out or • National or local regulations become wrapped around the may regulate the use. Comply cutter or cutter guard. to given regulations. • Check the motor for dirt and Personal safety cracks. Clean off grass and leaves from the engine using •...
  • Page 6 • Never allow children or other people or their property to persons not trained in the use accidents or hazards. of the product and/or the • The transport guard must battery to use or service it. always be used for storage Local laws may regulate the and transport.
  • Page 7 • All covers, guards and all situations which you consider handles must be fitted before to be beyond your capability. If starting. you still feel uncertain about operating procedures after • Only use the machine in reading these instructions, you daylight or in other well-lit should consult an expert before conditions.
  • Page 8 cause serious injury or death modified without the to the operator or others. permission of the manufacturer. Always use • Do not use the product if it is original accessories. Non- changed from its initial authorized modifications specification. Do not change and/or accessories can result a part of the product without in serious personal injury or...
  • Page 9 • Do not allow children to use objects such as stones, or be in the vicinity of the broken glass, nails, steel wire, product. Since the product is string, etc., that could be easy to start, children may be thrown out or become able to start it if they are not wrapped around the cutting kept under full surveillance.
  • Page 10 the product, stop and • Never work from a ladder, deactivate the product. Make stool or any other raised sure that the cutting position that is not fully attachment stops completely. secured. Remove the battery before • If any unwanted vibrations you clean, inspect or repair occur, tap out new line to give the product and/or the cutting...
  • Page 11 between the guard and the • Always use approved cutting attachment. personal protective equipment when you use the • This product produces an product. Personal protective electromagnetic field during equipment cannot fully operation. This field may prevent injury but it decreases under some circumstances the degree of injury if an interfere with active or...
  • Page 12 long pants and long sleeves. WARNING: Hearing Do not use loose clothing that protectors limit the can catch on twigs and ability to hear sounds branches. Do not wear and warning signals. jewelry, short pants, sandals • Use approved eye protection. or go with bare feet.
  • Page 13 and maintained as described • Make sure that the trimmer line is wound tightly and equally around the drum to prevent unusual in this section. If your product vibrations from the product. Different cord lengths can result in vibrations that are not necessary. Tap fails any of these checks, the trimmer head to get correct length on the cord.
  • Page 14 both move back to their original positions. This To do a check of the cutting attachment guard movement is operated by independent springs. WARNING: Do not use a cutting attachment without an approved and correctly attached cutting attachment guard. Always use the recommended cutting 1.
  • Page 15 (14 °F) and 40 °C (114 °F). supply for the related • Do not clean the battery or Husqvarna products only. To the battery charger with prevent injury, do not use the To clean the water. Refer to...
  • Page 16 • Do not use a defective or • Do not put objects into the damaged battery charger. cooling slots of the battery charger. • Do not lift the battery charger by the power cord. To • Do not connect the battery disconnect the battery charger terminals to metal charger from a mains socket,...

  • Page 17: Assembly

    water. Strong detergent can all checks in this operator's cause damage to the plastic. manual are approved after you have done maintenance, • If you do not do maintenance, turn to your servicing dealer. it decreases the life cycle of We guarantee that there are the product and increases the professional repairs and...
  • Page 18 To connect the battery to the product To charge the battery Note: Charge the battery if it is the first time that you use WARNING: Only use Husqvarna original it. A new battery is only 30% charged. batteries with the product.
  • Page 19 To start the product To cut the grass 1. Make sure that the trimmer line is parallel to the 1. Press and hold the start/stop button until the green ground when you cut the grass. LED is lit. 2. Use the power trigger to control the speed. To operate the product 2.

  • Page 20: Maintenance

    1. Push the SavE button to start the function. The Note: It is easier to tap out the trimmer line to make it green LED comes on to show that the function is on. longer when the trimmer head turns clockwise. Automatic shutdown function The product has an automatic shutdown function that stops the product if the product is not used.
  • Page 21 Maintenance Daily Weekly Monthly Make sure that the cutting attachment is not damaged. Replace the cutting at- tachment if it is damaged. Make sure that the cutting attachment guard is not damaged. Replace the cut- ting attachment guard if it is damaged. Make sure that the screws and nuts are tight.

  • Page 22: Troubleshooting

    3. Remove the nut that holds the trimmer head and the 4. Replace the trimmer head. drive disc. 5. Install the nut. 6. Install the line chute assembly. 7. Install the trimmer head. Troubleshooting Keypad LED display Possible faults Possible action Green activate LED flashing Low battery voltage.

  • Page 23: Transportation, Storage And Disposal

    5°C/41°F and 40°C/104°F. Note: The symbol shows on the product or package of • Charge the battery 30% to 50% before you put it in the product. storage for long periods. Technical data Technical data 520iLX Motor 756 - 003 - 24.06.2020...
  • Page 24 Frequency, Hz 50-60 50-60 Power, W The Husqvarna Handheld Battery products marked with IPX4 fulfils these requirements on product approval level Noise emissions in the environment measured as sound power (L ) in conformity with EC directive 2000/14/ EC. The difference between guaranteed and measured sound power is that the guaranteed sound power also includes dispersion in the measurement result and the variations between different machines of the same model according to Directive 2000/14/EC.

  • Page 25: Accessories

    Accessories Approved accessories Approved accessory Type Cutting attachment guard, art no Trimmer head T25B (Ø 2.0 mm - Ø 2.4 mm 577 01 83-03 Whisper line) J-handle set J-handle 587 37 50-01 756 - 003 - 24.06.2020...

  • Page 26: Ec Declaration Of Conformity

    EC Declaration of conformity Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare that the battery trimmer Husqvarna 520iLX with serial numbers dating from 2018 onwards (the year is clearly stated on the rating plate, followed by the serial number), comply with the requirements of the COUNCIL’S DIRECTIVE:...
  • Page 27 T25B Li-ion Li-ion 6,0 m 10 cm 4" 3,05 m "Clic" 15 cm 6"...
  • Page 28 Original instructions 1142405-26 2020-06-29...

Table of Contents