Advertisement
1-3. Opening and Closing the Inside Panel Assembly
1-3. Opening and Closing the Inside
Panel Assembly
Opening
n
Be sure to set the POWER switch to OFF, unplug the
power cord or remove the battery before starting any of the
following procedure to protect inside of the unit from
damage.
1. Loosen the four screws (with drop-safe) and open the
inside panel assembly in the direction of the arrow.
m
. The flexible card wire that is connected to the FP-
148 board, will be significantly shortened of its life
if it is folded. Be very careful not to fold the flexible
card wire.
. Stand the unit in the posture that the POWER switch
side faces upward when the inside panel assembly is
opened.
POWER switch
Inside panel
assembly
Screws
(with drop-safe)
Hook
Hinge
FP-148 board
1-2 (E)
Hook
Hinge
Screws
(with drop-safe)
Inside panel
assembly
Flexible card wire
Screws
(with drop-safe)
Closing
1. Check that the hinges in the right and left are engaged
securely with the hooks of the chassis.
2. Insert the inside panel assembly and tighten the four
screws (with drop-safe).
n
Standard tightening torque :
Screw (with drop-safe, B3 x 12)
0.8 N.m (8.0 kgf.cm)
n
Be careful not to pinch the harness between the inside
panel assembly and the chassis.
CBK-MB01
Advertisement
