Advertisement
1-4. Removing and Installing the DCP Board Assembly
9. Slant the DCP board assembly to the front and remove
it.
DCP board assembly
Reinstallation
1. Reinstall the DCP board assembly by reversing the
steps 4 to 9 of removal.
m
. Route the harnesses coming from the connectors
(CN1, CN3 and CN4) of the VA-228 board so that
they do not jump out of the surface (the surface
shown by the arrow) on the VA-228 board.
. Route the harnesses so that it is positioned in the
recessed portion of the DCP-38 board.
Harness (MA)
Recess of
the DCP-38 board
Harness
1-4 (E)
2. Continue reinstallation of the DCP board assembly by
3. Close the inside panel. (Refer to Section 1-3.)
DCP-38 board
n
Tightening torque :
VA-228 board
Removal step 6, DCP board assembly (B2.6 screw): 53 x
10
CN4
CN3
CN1
reversing the steps 2 to 3 of removal.
m
. When installing the filter cover, route the harness
(MA) connected from the CN-2437 board to the SE-
803 board so that it passes near the screw that
secures the upper end of the DCP-38 board. At that
time, ensure that the harness (MA) passes between
the guides at the upper right and left of the filter
cover.
Filter cover
upper guides
Harness (MA)
Filter Knob
SE-803 board
Filter cover
. After the CN-2437 board is reinstalled, rotate the
filter knob in both directions to confirm that it is not
caught by the harness (MA).
. Be careful that the harness must not be pitched
between the inside panel and the chassis.
± 0.01 N.m (5.3 ± 0.1 kgf.cm)
-2
DCP-38 board
Screw
CBK-MB01
Advertisement
