Fujitsu PRIMERGY CX25 0 M4 Series Disassembly And Recycling Document page 75

Removing the TPM
Figure 100: Removing the TPM screw
Ê Locate the slotted lower end of the TPM screw (1).
Ê Loosen the TPM screw using a thin slotted screw driver (e.g. watchmaker's
screw driver) or the dedicated TPM screw driver (for Japan) (2).
Ê Remove the TPM screw (3).
Ê Remove the TPM on the upper side of the system board.
Figure 101: Removing the TPM spacer
Ê Using a pair of flat nose pliers, press together the hooks on the TPM spacer
(see arrows) and remove it from the system board.
CX400 M4
Disassembly and Recycling Instructions
Disassembly and recycling
75