Sony BDX-M1000 Installation Manual page 9

Required parts
. Rack Mount Rail, RMM-30
Rail with bracket
Screw (B5x8)
. Screw for inner rail (B4x8)
. Screw for rack mounting (RK5x16) : 4 pcs.
(Sony part number: 7-682-378-04)
. Washer for rack mounting
(Sony part number: 2-297-913-01)
(*1) : The BDX-M1000 comes with the eight screws. The
two screws of them are spare.
n
Be sure to use the RMM-30 Rack Mount Rail.
If a rack mount rail other than the RMM-30 is used, the
BDX-M1000 may be dropped by insufficient strength of
the rack mount rail. This may cause a injury.
Procedures
1. Turn the power off.
2. Remove the four feet from the bottom of the BDX-
M1000.
Feet
BVTT 3x12
BDX-M1000
: 2 pcs.
: 8 pcs.
(*1)
: 6 pcs.
: 4 pcs.
Feet
BVTT 3x12
3. While pressing the stopper of the rail, pull out the
inner rail.
Outer rail
4. Attach the inner rails to the BDX-M1000 using the six
screws (B4x8) supplied with the BDX-M1000.
B 4x8
5. Loosen the screws fastening the rear bracket to the
outer rail, and adjust the position of the rear bracket
with the rack depth.
Rear bracket
Outer rail
1-4. Rack Mounting
Stopper
Inner rail
Inner rail
Inner rail
B 4x8
Front bracket
1-3 (E)