Installation Diagram Of Indoor And Outdoor Units; Optional Installation Parts - Toshiba RAS SKV Series Installation Manual

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS

Batteries
Wireless remote control
RAS-077, 107, RAS-167SAV
137SAV Series Series
600 600
C
D 400 600
E 45 100
F 100 100
Remark :
• Detail of accessory and installation parts can see in the accessory
sheet.
• Some pictures might be different from the actual parts.

Optional Installation Parts

Part
Parts name
code
Refrigerant piping
Liquid side : Ø6.35 mm
Ø9.52 mm
(RAS-077, 107, 137SKV Series)
Gas side : Ø12.70 mm
(RAS-167SKV Series)
Pipe insulating material
(polyethylene foam, 6 mm thick)
Putty, PVC tapes
Flat head
Remote control holder
wood screw
Vinyl tape
Apply after carrying
out a drainage test.
• Secure the outdoor unit with fixing bolts and nuts if the unit is likely to be
exposed to a strong wind.
Q'ty
• Use Ø8 mm or Ø10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple
water proof
One
each
1
One
each
RAS-077, 107, 137SAV Series
2
For the rear left and left piping
Hook
Installation
plate
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
Do not allow the drain hose to get slack.
Shield pipe
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom
right
Saddle
Insulate the refrigerant pipes separately
with insulation, not together.
Extension drain hose
(Not available, provided
by installer)
6 mm thick heat resisting
polyethylene foam
Fixing bolt arrangement of outdoor unit
to the bottom plate of the outdoor unit before installing it.
28 mm
500 mm
Air inlet
97 mm
Air outlet
Drain outlet
Wall
Cut the piping
hole sloped
slightly.
Left
Rear
left
Bottom left
and cap
108 mm 125 mm
Air inlet
Air outlet
90 mm
600 mm
Drain outlet
RAS-167SAV Series