General Information; Diagnosis; Test Mode - Pioneer DRM-7000 Service Manual

DRM-7000, DRM-AF751, DRM-AL751, DRM-AH721, DRM-PW701

7. GENERAL INFORMATION

7.1 DIAGNOSIS

7.1.1 TEST MODE

Entering Test Mode
(1) After the power is turned on and the initialization of the mecha-
nism ("Initializing" is displayed) is completed, the following
indication is displayed.
(2) Unlock the keys and press the FUNCTION key.
The following indication is displayed:
(3) Press the FUNCTION and ±= keys simultaneously for 4
seconds. The following indication is displayed:
(4) Press the ENT key. The following indication is displayed:
(5) Move the cursor to the mode of your choice by pressing the
±= or +≠ key, then press the ENT key.
Diag mode
Robotics
Individually
To Manual/Auto mode
• Elevation Manual/Auto
(Elevation Manual/Auto operation mode)
• Loading Manual/Auto
(Loading Manual/Auto operation mode)
• Flip-unit Manual/Auto
(Flip-unit Manual/Auto operation mode)
• Clamper Manual/Auto
(Clamper Manual/Auto operation mode)
• Mailslot Manual/Auto
(Mailslot Manual/Auto operation mode)
• Hyper-Mag. Manual/Auto
(Hyper magazine Manual/Auto operation
mode)
Collectively
To Step mode
Drive
To Drive mode
Sensor
To Sensor mode
128
The unit is in User mode.
The unit enters System
management mode.
Asking if you wish to enter Test
mode.
The unit enters Test mode.
The cursor is blinking on D (Diag).
Specifications of Demo mode
(1) Move the cursor to Demo by pressing the ± key, then press
the ENT key to display the Demo Mode Select screen.
Select Demo 1, 2 or 3 mode by pressing the ±= or +≠ key.
Demo 1
±= +≠
Demo 2
±=
+≠
Demo 3
(2) Press the ENT key to enter the demo mode you have selected.
Demo 1
Preparation :
Set 16 discs each into Hyper magazines #1-16 (from the lowest
to the 16th slots).
Operational steps :
(1) The disc in Hyper magazine #1 is carried and inserted into
the rear Bay #1 drive unit.
(2) The disc in Hyper magazine #2 is carried and inserted into
the rear BAY #2 drive unit.
(16) The disc in Hyper magazine #16 is carried and inserted into
the rear Bay #16 drive unit.
(17) All the transferred discs start rotating. Demo 1 completed.
Indications :
OK
Operation completed.
Note: If a drive unit is not installed at the rear Bay, the disc is
carried to the location where the specified drive unit should
be installed then returned to the original Hyper magazine.
In this mode, a disc is carried
to the drive unit, the drive unit
is started, then stops.
Discs must be set in Hyper
magazines #1 to #16.
In this mode, two discs are
carried one after another to
one drive unit.
Two discs are required.
In this mode, discs are carried
to all magazines installed, one
after another.
Discs must be set in Hyper
magazines #1 to #4.
A disc is being
carried to the drive
unit.
Operation completed.