Pioneer DRM-7000 Service Manual page 131

DRM-7000, DRM-AF751, DRM-AL751, DRM-AH721, DRM-PW701
4. Quitting from Nonfatal Error Status (Mainly Errors with the Drive)
When an error occurs during mechanism initialization:
(Check whether it is
the UNLOCK status.)
FUNCTION
• If the indication returns from "Initializing" to an error indication again, it is necessary to manually open the door and remove the
drive that caused the trouble. Following "7.1.3 DISASSEMBLY", open the rear door, disconnect the drive mounted on the drive
bay (Bay 1 to Bay 16) having the corresponding number to the suffix (0 to F) of the error code, then remove it. When you close the
door, initializing of the mechanism begins.
• Sufficient care must be taken when checking the drive, since disconnecting/reconnecting the changer interface is equivalent to
disconnecting/reconnecting the entire drive unit.
• If a disc remains in the removed drive, manually take it out. NEVER return the drive with a disc remaining inside to the changer.
As the disc is not detected, and this may cause a secondary problem.
When an error occurs in a mode other than mechanism initialization:
(Check whether it is
the UNLOCK status.)
FUNCTION
Select NO then ENT .
• The requirements and operation procedure when the indication returns from "Initializing" to the previous error indication are the
same as those "when an error occurs during mechanism initialization," mentioned above.
• When you specify "Initializing NO," Inquiry submode is selected. Change to Door submode to open the door, and remove the
defective drive.
Hyper-magazine timeover
(Check whether it is
the UNLOCK status.)
FUNCTION
• If memory of a hyper magazine cannot not be read, a warning message is displayed. Error EE0 is generated by a timeout in an
inserting/ejecting operation, which has no relationship to memory. In either cases, normal condition may be restored by once
ejecting the hyper magazine and then reinserting it.
ENT
Select YES then ENT .
ENT
131