Advertisement
Main
Sub
code
code
26
69
Toner near end environment setting (Function)
This simulasion is used to set the operating conditions for toner near end. The setting mode is switched by
[Density select] key.
The set value of the selected mode is displayed on the LCD display.
When the code number is entered and [START] key is pressed, the setting is switched.
<Toner near end display /No display>
Code number
<Setting of operations at toner end>
Code number
73
Toner save setting display/non-display
Used to set Enable/Disable of the toner save setting in the system settings. If this setting is set to Enable (1),
the toner save setting appears in the system settings to allow setting.
Sim26-73 TS ENABLE
1:TS ENABLE
[
0- 1]
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
74
Total counter display change setting
Used to set whether the scanner counter value is added to the total counter display in the system settings.
Sim26-74 ADD COUNT
1:ADD SCAN CNT
[
0- 1]
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
30
01
Paper sensor status display
Used to display the list of paper sensor status on the LCD. An active sensor is highlighted.
The display items and corresponding sensors are shown below.
Sim30-1 SENSOR
POUT
DPX
MBEMP C1EMP C2EMP
C3EMP
C4EMP
C3PSS C4PSS
When a multi-stage cassette is not installed as an option, the corresponding sensor name is not displayed.
0
1
0
1
2
Display: Setting
0 : Disable
0
1 : Enable
0
0 : Scan counter not added
1 : Scan counter added
0
0
Display
: Corresponding sensor
PIN
POUT
: Paper exit sensor
DPX
: DUPLEX sensor
C2PSS
PIN
: Paper entry sensor
MBEMP
: Manual feed paper sensor
C1EMP
: No. 1 tray paper sensor
C2EMP
: No. 2 tray paper sensor
C3EMP
: No. 3 tray paper sensor
C4EMP
: No. 4 tray paper sensor
C2PSS
: No. 2 tray paper feed sensor
C3PSS
: No. 3 tray paper feed sensor
C4PSS
: No. 4 tray paper feed sensor
MX-M182 SIMULATIONS 7-26
Contents
Setting contents
Toner near end is displayed
Toner near end is not displayed
Setting contents
Operation setting 1
Operation setting 2
Operation setting 3
Remark
Default:
1
Default:
0
Advertisement
