Installing A Hard Drive Carrier Into A Front Drive Bay; Identifying A Faulty Ssd Drive; Installing A Ssd Hard Drive Into A Rear Drive Bay; Removing A Hard Drive Carrier From A Rear Hard Drive Bay - Bosch DIVAR IP all-in-one 7000 3U Installation Manual

38 en | Maintenance
9.4.3

Installing a hard drive carrier into a front drive bay

To install a hard drive carrier into a hard drive bay:
1.
2.
9.5

Identifying a faulty SSD drive

The system provides tools for hard drive monitoring that are pre-installed on the system.
Use the Intel Rapid Storage tool to identify a faulty SSD drive, if the RAID 1 mirror that holds
the operation system partition is running in degraded mode.
To identify and replace SSD drives:
1.
2.
3.
4.
9.6

Installing a SSD hard drive into a rear drive bay

The unit features two hot-swappable hard drives on the rear side which can be removed
without powering down the system.
The hard drives are mounted in hard drive carriers to simplify their installation and removal
from the chassis. These hard drive carriers also help promote proper airflow for the hard drive
bays.
Procedure
To install a SSD hard drive into the rear drive bay, you have to perform following steps:
1.
2.
3.
9.6.1

Removing a hard drive carrier from a rear hard drive bay

To remove a hard drive carrier from a hard drive bay:
1.
2020.04 | V1.1 | DOC
Insert the hard drive carrier horizontally into the hard drive bay, orienting the hard drive
carrier so that the release button is on the right.
Push the hard drive carrier into the bay until the handle retracts and the hard drive clicks
into the locked position.
Turn on the unit and log on as user BVRAdmin. The default screen is displayed.
Double-click the Intel Rapid Storage icon on the screen.
Check the status of the listed SSD drives and note the port numbers.
– SATA port 0: refers to the SSD located in the lower tray
– SATA port 1: refers to the SSD located in the upper tray
After you have identified the faulty SSD drive, open the corresponding tray on the back of
the system and replace the SSD drive.
Removing a hard drive carrier from a rear hard drive bay, page 38 .
Installing a hard drive into a rear hard drive carrier, page 39 .
Installing a hard drive carrier into a rear hard drive bay, page 40 .
Press the release button to the right of the hard drive carrier. This extends the hard drive
carrier handle.
Installation manual
DIVAR IP all-in-one 7000 (3U)
Bosch Security Systems B.V.