5 To 7 Conversion Kit
Reelmaster
Model No. 33452—Serial No. 400000000 and Up
Introduction
Visit
www.Toro.com
for product safety and operation
training materials, accessory information, help finding
a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Important:
With your mobile device, you can
scan the QR code (if equipped) on the serial
number plate to access warranty, parts, and other
product information.
1. Model and serial number location
Model No.
Serial No.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Transport Frame
Figure 1
Figure 1
Register at www.Toro.com.
Setup
1
Preparing the Machine
No Parts Required
Parking the Machine
1.
Park the reel frame on a level surface and lower
the cutting units to the ground.
2.
Engage the parking brake, shut off the engine,
remove the key, and wait for all moving parts
to stop.
3.
Chock the wheels of the reel frame to ensure
that the machine does not move.
Disconnecting the Hydraulic
Hoses
Hydraulic System Safety
•
Seek immediate medical attention if fluid is injected
g322493
into skin. Injected fluid must be surgically removed
within a few hours by a doctor.
•
Ensure that all hydraulic-fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
•
Keep your body and hands away from pinhole
leaks or nozzles that eject high-pressure hydraulic
fluid.
•
Use cardboard or paper to find hydraulic leaks.
•
Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
1.
At the transport frame control console, move the
3 control levers up and down to relieve hydraulic
pressure between the transport frame and the
tow vehicle
Original Instructions (EN)
Form No. 3434-988 Rev A
Operator's Manual
(Figure
2).
All Rights Reserved *3434-988* A
Printed in the USA