Toro FP Series Operator's Manual page 15

Servicing the Engine Oil
Oil Type: Detergent oil (API service SJ or higher)
Oil crankcase capacity:
•
0.56 L (0.59 US qt) for Model 68025
•
0.58 L (0.61 US qt) for Models 68026 and 68027
Viscosity: See table below
5W - 30 / 10W - 30
0 20 40
-20 -10 0 10
Figure 21
Changing the Engine Oil
Service Interval: After the first 25 hours
Every 100 hours
WARNING
Oil may be hot after the engine has been run, and
contact with hot oil can cause severe personal injury.
Avoid contacting the hot engine oil when you drain
it.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug.
3. Remove the drain plug (Figure 22).
Figure 22
1. Drain plug
30
o
60 80 100 F
o
20 30 40 C
g013375
g019692
Note: You may have to tip the compactor backwards
to drain the oil.
4. When the oil has drained completely, replace the plug.
Note: Dispose of the used oil at a certified recycling
center.
5. Remove the dipstick (Figure 7) and slowly pour oil into
the filler hole until the oil pours out of the filler hole.
6. Replace and secure the dipstick.
7. Wipe up any spilled oil.
Servicing the Eccentric Oil
Oil type: 10W30 (API service SJ or higher)
Oil capacity:
•
1.3 L (1.4 US qt) for Model 68025
•
3.3 L (3.5 US qt) for Model 68026
•
3.5 L (3.7 US qt) for Model 68027
Checking the Eccentric-oil Level
Service Interval: Monthly
1. Set the throttle to slow, stop the engine, and wait for
all moving parts to stop.
2. Place a drain pan under the oil plug and remove the oil
plug screw on the side of the eccentric housing (Figure
23).
1. Oil plug
3. Verify that the eccentric oil is level with the bolt hole.
Note: If adding oil is required, refer to Changing the
Eccentric Oil (page 16).
4. Wipe up any spilled oil.
5. Replace the oil plug screw.
15
Figure 23
2. Eccentric-oil-filler hole