Installing The Safety Chain - Toro CM-658H-S Operator's Manual

3

Installing the Safety Chain

Parts needed for this procedure:
1 Safety chain
2 Connecting link
Models 68004, 68006, and 68009
(Side-dump)
1. Form a hook on the end of a bendable piece of rod or
stiff wire, (not included), and insert it through both
keyholes in the front post of the machine (Figure 8A).
A
C
1. Keyhole
2. Rod or wire (not included)
2. Attach the safety chain to the length of rod or wire
(Figure 8A).
3. Pull the rod, or wire, and the safety chain through both
keyholes (Figure 8B).
Note: Ensure that approximately equal lengths of
safety chain extend from either side of the front post.
B
1
2
3
D
4
3
Figure 8
3. Safety chain
4. Connecting link
Models 68007 and 68008 (End-dump)
1. Form a hook on the end of a bendable piece of rod
or stiff wire (not included) and insert it through both
keyholes in the tongue of the machine (Figure 9).
A
C
1. Keyhole
2. Rod or wire (not included)
2. Attach the safety chain to the length of rod or wire
(Figure 9).
3. Pull the rod, or wire, and the safety chain through both
keyholes (Figure 9).
Note: Ensure that approximately equal lengths of
safety chain extend from either side of the tongue.
g019883
Installing the Connecting Links
1. Align the connecting link to the last link in one end of
the safety chain (Figure 8D and Figure 9D).
2. Insert the connecting link through the chain link until
the connecting link snaps closed.
3. Repeat steps 1 and 2 to install the other connecting link
in the other end of the safety chain.
11
B
1
2
3
D
4
3
Figure 9
3. Safety chain
4. Connecting link
G019919