Controls - Toro CM-658H-S Operator's Manual

Controls

Become familiar with all of the controls before you start the
engine and operate the machine.
Engine Switch
When the engine switch on the cowl is in the Run position,
it allows the engine to run. Moving the engine switch to the
Stop position stops the engine.
Handwheel
The handwheel controls the discharging action of the drum.
Drum-tilt Brake
The drum-tilt brake locks the drum into an upright position
or a discharging position.
Engine Controls
4
3
2
1
1. Recoil-start handle
2. Fuel valve
3. Choke lever
4. Throttle lever
Fuel Valve
The fuel valve (Figure 13) is located underneath the choke
lever. Move the lever for the fuel valve to the On position
before attempting to start the engine. When you have finished
mixing, stop the engine and move the fuel valve lever to the
Off position.
5
7
8
Figure 12
5. Fuel cap
6. Dipstick
7. Oil-drain plug
8. On/Off switch
1
1. Fuel valve
2. Choke lever
Choke Lever
Use the choke lever (Figure 13) to start a cold engine. Before
pulling the recoil-start handle, move the choke lever to the
closed position. Once the engine is running, move the choke
lever to the open position. Do not use the choke if the engine
is already warmed up or the air temperature is high.
Throttle Lever
6
The throttle lever (Figure 13) controls the speed (rpm) of the
engine. It is located next to the choke lever. It sets the engine
speed and therefore can increase and decrease the rotation
speed of the mixing paddles. For best performance, set this
control to the fast position when mixing material.
Engine On/Off Switch
The On/Off switch (Figure 14) allows the operator of the
G019744 machine to start and stop the engine. This switch is located
on the front of the engine. Rotate the On/Off switch to the
On position to start and run the engine. Rotate the On/Off
switch to the Off position to stop the engine.
1
1. Off position
13
2
G018792
Figure 13
3. Throttle lever
OFF
2
Figure 14
2. On position
3
OFF
G021 103