Table of Contents
Advertisement
Operation
Controls
Light Switch
Press the light switch (Figure 18) to the On position to
activate the head lamps.
1
Figure 18
1. Light switch
Hazard Switch
Press the hazard switch (Figure 19) to the On position to
activate the front and rear flashing hazard lights.
Figure 19
1. Hazard switch
2. Turn signal switch
Turn Signal Switch
Press down on the left side of the turn signal switch (Figure
19) to activate the left turn signal. The center position is off.
Press down on the right side of the turn signal switch (Figure
19) to activate the right turn signal. The center position is off.
Horn
Press the horn button to activate the horn (Figure 19).
g021721
g021733
3. Horn button
Aiming the Headlights
1. Loosen the mounting nuts and position each headlight
so that it points straight ahead.
2. Tighten each mounting nut just enough to hold the
headlight in position.
3. Place a flat piece of sheet metal over the face of the
headlight.
4. Mount a magnetic protractor onto the plate.
5. While holding the assembly in place, carefully tilt the
headlight downward 3 degrees, then tighten the nut.
6. Repeat the procedure for the other headlight.
11
Advertisement
Table of Contents
