Table of Contents
Advertisement
4
Installing the Horn
Parts needed for this procedure:
1
Horn
1
Bolt (5/16 x 3/4 inch)
1
Flange nut (5/16 inch)
1
Horn switch
1
Horn button, rubber
Procedure
1. Install the horn bracket to the tab, under the platform,
with a bolt (5/16 x 3/4 inch) and lock nut (3/8 inch)
(Figure 5). Rotate the horn so it faces toward the back
of the machine.
1
2
3
1. Flange nut
2. Horn
2. Insert the horn switch through the hole in the steering
column tower (Figure 6).
Figure 5
3. Bolt
1
1. Horn switch
3. Secure the horn switch to the tower by threading on
the rubber horn button (Figure 6).
4. Locate the wire harness connectors inside the steering
column tower. Plug the wire harness connectors
labeled "horn" into the horn and switch.
5. Secure the wire harness.
Note: When routing the wires, ensure that the
operation of the tilt steering does not damage the
harness or pull on the wires.
5
Installing the Headlights
Parts needed for this procedure:
1
Headlamp bracket, R.H. (for models 30605 and 30609)
1
Headlamp bracket, L.H. (for models 30605 and 30609)
g021716
2
Rubber grommet (for models 30605 and 30609)
Headlamp bracket (for model 30602, 30603, 30606
2
and 30607)
1
Headlamp bracket, R.H. (for model 30604 and 30608)
1
Headlamp bracket, L.H. (for model 30604 and 30608)
2
Screw, 1/2 x 1 inch
2
Locknut, 1/2 inch
1
Headlamp R.H.
1
Headlamp L.H.
1
Wire harness, headlight
2
Harness clip
For Groundsmaster 4000, Model 30605
and 30609
1. Remove the (2) bolts, washers and nuts from the front
of the operator's platform (Figure 7).
5
Figure 6
2. Horn button
2
g021715
Advertisement
Table of Contents
