Advertisement
Quick Links
Tilt Steering Kit
RT1200 Traction Unit
Model No. 25497
Model No. 25497E
Installation
This product contains a chemical or chemicals known to the State of California to
1
Preparing to Install the
Tilt-Steering Column
No Parts Required
Procedure
1. Move the machine to a level surface.
Note: Ensure that the front wheels of the machine
are straight.
2. Set the parking brake, shut off the engine, and remove
the key from the key switch.
3. Remove the right panel; refer to the Operator's Manual.
4. Rotate the battery-disconnect switch to the O
position; refer to the Operator's Manual.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
FF
Register at www.Toro.com.
2
Removing the Steering Wheel
No Parts Required
Procedure
1. Pry the cover out from the hub of the steering wheel
(Figure
1).
1. Cover
2. Nut (13/16 inch)
2. Remove the nut (13/16 inch) that secures the steering
wheel to the fixed-steering column
3. Remove the steering wheel by pulling it away from the
column
(Figure
1).
Original Instructions (EN)
All Rights Reserved *3398-100* A
Printed in the USA
Form No. 3398-100 Rev A
Installation Instructions
Figure 1
3. Steering wheel
4. Fixed-steering column
(Figure
1).
Advertisement
Related Manuals for Toro 25497
Summary of Contents for Toro 25497
- Page 1 Form No. 3398-100 Rev A Tilt Steering Kit RT1200 Traction Unit Model No. 25497 Model No. 25497E Installation Instructions Installation WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 3. Remove the 4 bolts (3/8 x 1-1/2 inch) and 4 washers (3/8 inch) that secure the fixed-steering column and the steering valve to the steering support (Figure Note: Do not discard the washers. Removing the Fixed-Steering Column No Parts Required Procedure 1.
-
Page 3: Installing The Column
Figure 7 1. Hole (steering support) 3. Spline socket (steering valve) 2. Threaded hole (steering valve) Figure 6 2. Align the tilt-steering column to the steering valve with 1. Steering support 2. Fixed-steering column the short-spline shaft down and the word P that is embossed in the boot of the column rearward (Figure... -
Page 4: Installing The Steering Wheel
Installing the Steering Wheel No Parts Required Procedure 1. Apply medium-grade, thread-locking compound to the threads of the steering-wheel shaft. 2. Align the spokes of the steering wheel (Figure 10). Figure 9 1. Spline socket (steering 4. Tilt-steering column valve) 2. -
Page 5: Operation
Operation Adjusting the Tilt Steering Column 1. Stop the machine and set the parking brake. 2. Hold the steering wheel with 1 hand. 3. Press the latch mechanism (located under the word that is embossed in the boot of the steering column) until the column unlocks (Figure 11). - Page 6 Notes:...
- Page 7 Notes:...