Dvd Drive - Canon imagePRESS Server F200 Installation And Service Manual

R
EPLACING PARTS

DVD drive

The DVD drive is attached to the switch bank assembly. The DVD drive is used to install
system software onto the hard disk drive and archive data onto writable media.
T DVD
O REMOVE THE
1 Shut down, and then open the imagePRESS Server (see pages
To remove the DVD drive, you must remove the left, right, and front panels, the component
sled, and the switch bank assembly.
2 Remove the power and data combination cable from the back of the DVD drive.
3 Remove the component sled from the chassis, and then remove the switch bank assembly
from the component sled (see
4 Remove the four screws that secure the DVD drive to the switch bank assembly.
Set aside the screws so that you can replace them later.
On some systems, a small metal post in the switch bank assembly is used in place of
N :
OTE
one of the screws.
DRIVE
page
33
73).
76
and 35).
Component sled
Switch bank assembly
Screw (1 of 3)