Silvercrest SLG 1.0 A1 Operating And Safety Instructions page 2

modifications to the USB charger adapter may result
in these directives no longer being met.
 If you are not using the charger adapter within the
Republic of Germany, you must observe the
regulations and laws in the country of use.
 Manufacturer: TARGA GmbH, Postfach 2244,
D-59482 Soest, Germany
Conformity Notice
This USB charger adapter complies with the basic and
other relevant requirements of EMC Directive
2004/108/EC and the Low-Voltage
2006/95/EC.
Technical data
Model USB charger adapter SLG 1.0
A1
Dimensions (diameter x H) 54 x 72 mm
Weight 45 g
Connection input UK plug
Connection output USB-A socket
Input voltage 100 – 240 V ~
50Hz / 60 Hz
Input current 0.15A
Output voltage 5 V
Output current 1A
Standby power 0 W
consumption
Compatibility USB 2.0, USB 1.1
Temperature 10 - 35 °C
Air humidity (rel. humidity) Max. 85 %
Troubleshooting
Problem Cause, action
Device is not charged  Press and hold the POWER button
[1] for at least 1 second to start the
charging process.
 Power socket defective or fuse
blown: check the power socket by
connecting a different device.
 No USB connection to device:
check the USB connection.
 The charging current is lower than
40 mA. It is not possible to charge
devices with a charging current
lower than 40 mA.
 Some devices, especially mobile
telephones, require a special USB
charging cable which you can buy
separately. This is not a
malfunction of the charger.
 The connected device is faulty or
cannot be charged via USB.
The USB charger  The standby current of the
adapter does not
connected device is too high. If
power off after the
necessary, power off the device
battery has been after the battery has been charged.
charged.
Directive
Warranty Information