General Radius Setup Procedure - HP ProCurve 6400cl Series Access Security Manual

• Determine the access methods (console, Telnet, Port-Access (802.1X), web browser interface (5300xl switch only),
and/or SSH) for which you want RADIUS as the primary authentication method. Consider both Operator (login) and
Manager (enable) levels, as well as which secondary authentication methods to use (local or none) if the RADIUS
authentication fails or does not respond.
Figure 6-1. Example of Possible RADIUS Access Assignments
• Determine the IP address(es) of the RADIUS server(s) you want to support the switch. (You can configure the switch
for up to three RADIUS servers.)
• If you need to replace the default UDP destination port (1812) the switch uses for authentication requests to a specific
RADIUS server, select it before beginning the configuration process.
• If you need to replace the default UDP destination port (1813) the switch uses for accounting requests to a specific
Radius server, select it before beginning the configuration process.
• Determine whether you can use one, global encryption key for all RADIUS servers or if unique keys will be required
for specific servers. With multiple RADIUS servers, if one key applies to two or more of these servers, then you can
configure this key as the global encryption key. For any server whose key differs from the global key you are using,
you must configure that key in the same command that you use to designate that server's IP address to the switch.
• Determine an acceptable timeout period for the switch to wait for a server to respond to a request. HP recommends
that you begin with the default (five seconds).

General RADIUS Setup Procedure

Preparation:
1. Configure one to three RADIUS servers to support the switch. (That is,
one primary server and one or two backups.) Refer to the documentation
provided with the RADIUS server application.
2. Before configuring the switch, collect the information outlined below.
Table 6-1. Preparation for Configuring RADIUS on the Switch
RADIUS Authentication and Accounting

General RADIUS Setup Procedure

Note: The Webui access
task shown in this figure is
available only on the 5300xl
switches running software
release E.09. xx
Console access requires
Local as secondary
method to prevent lockout
if the primary RADIUS
access fails due to oss of
RADIUS server access or
other prob ems w th the l
server.
or greater.
l
i
6-7