Procedure
1. Secure the holding plate
⑤
bolts M5
. Use spring washers and normal washers. The tightening torque
is 5.7 Nm.
2. Secure the support
and the nut. Use a spring washer and normal washer. The tightening torque
is
24 Nm.
3. Arrange the clamping bracket
figures top right) and lay it on the support
4. Screw the clamping bracket
⑦
bolts M8
and nuts. Select the bolt length according to the mast thickness. The
tightening torque is 14 Nm.
5. Align the antenna. To do this loosen the threaded bolt
and then tighten the threaded bolt
Antenna ANT793-8DK
A5E03484060-03, 09/2017
③
to the back of the antenna
②
to the holding plate
①
according to the thickness of the mast (see
①
and the support
⑥
again.
④
with four threaded
③
using the threaded bolt M8x40
②
.
②
together with two threaded
⑥
. Position the antenna
8BInstallation
⑥
33