Silvercrest SMH 30 A1 Assembly Instructions Manual page 8

Step 2: Push the profile rails into the wall bracket
♦ Push the profile rails into the wall bracket (1.).
♦ Screw the two locking screws Ø 4 x15 mm
below to stop the profile rails from falling out of the wall bracket (2.).
♦ Push the two screw covers
NOTE
► If you want to use the entire width of the wall bracket, you can leave out
the locking screws Ø 4 x15 mm
longer be secured.
Step 3: Fitting the extension rails
NOTE
The grooves in the profile and extension rails are intended for the placement
of your appliance. Align your appliance as far as possible towards the wall.
This will provide the best hold.
► Measure the distance between the feet of your appliance.
► Align the profile and extension rails according to this.
♦ Push the extension rails into the profile rails, taking into account the distance
you just measured (1.).
♦ Ensure that you attach the two locking screws Ø 6 x 20 mm
locking mechanism. This will prevent the extension rails from falling out (2.).
│ GB │ CY
■ 6
into the wall bracket from
E
over the locking screws Ø 4 x15 mm
F
. Bear in mind that the profile rails will no
E
F
E
(3.).
E
behind the
A
SMH 30 A1