Getting Started; Switching The Fan Heater On And Off - Silvercrest SHLF 2000 C1 Operating Instructions And Safety Instructions

If the battery in the remote control (19) is empty, replace it with a new type CR2025 3 Volt battery.
The procedure is as follows:

Press the closure flap on the battery holder of the remote control (19) towards the centre
(Diagram A). Pull the battery holder out.

Remove the empty battery and insert a new battery. Make sure the polarity is correct (+/-).

Push the battery holder back into the remote control (19) until the closure flap clicks into
place.

8. Getting started

DANGER! When switched on, the temperature of exposed surfaces may be very high.
There is a risk of getting burnt!
DANGER! Always unwind all the power cable (9). There is a risk of fire.
DANGER! Keep a clearance of at least one metre to walls, furniture and other devices.
There is a risk of fire.
When you use it for the first time, smells or slight smoke may develop. This is normal and
perfectly safe. However, do make sure there is sufficient ventilation.

Switch the main switch (8) off.

Plug the mains plug into an easily accessible mains socket.
You can operate the fan heater in the same way from the control panel (1) of the fan heater or
using the remote control (19). The buttons on the control panel (1) and on the remote control (19)
have the same labels and the same function. The description below and the reference numbers
used relate to operation from the control panel (1).

8.1 Switching the fan heater on and off


Switch the main switch (8) on. The main switch (8) and the display (10) light up. The timer (32)
flashes on the display (10). The fan heater is now in standby mode and can be operated from
the control panel (1) or the remote control (19).

To use the fan heater, press the
The power indicator (14) goes red.

To switch the fan heater back to standby mode, press the
indicator (14) then goes out.
Please note that the fan heater consumes minimal electricity when in standby mode.

In order to switch the fan heater off completely, it needs to be switched off from the main switch
(8).
Even when the main switch (8) off, the full mains voltage is live in the device. Only
unplugging the mains plug disconnects the fan heater completely.
button (11).
SilverCrest SHLF 2000 C1
button (11) again. The power
English - 35