Step 4: Configure Sip Signaling Interfaces - NEC SV9100 Configuration Note

4.4

Step 4: Configure SIP Signaling Interfaces

This step describes how to configure SIP Interfaces. For the interoperability test topology,
an internal and external SIP Interface must be configured for the E-SBC.

To configure SIP Interfaces:
1. Open the SIP Interface Table page (Configuration tab > VoIP menu > VoIP Network
> SIP Interface Table).
2. Add a SIP Interface for the LAN interface. You can use the default SIP Interface
(Index 0), but modify it as shown below:
Index
Interface Name
Network Interface
Application Type
UDP Port
TCP and TLS
Media Realm
3. Configure a SIP Interface for the WAN:
Index
Interface Name
Network Interface
Application Type
UDP Port
TCP and TLS
Media Realm
AudioCodes Mediant E-SBC
Parameter
Parameter
30
SV9100 IP-PBX & BroadCloud SIP Trunk
Value
0
IP-PBX (see Note on page 31)
Voice
SBC
5060
0
MRLan
Value
1
BroadCloud (see Note on page 31)
WANSP
SBC
5060
0
MRWan
Document #: LTRT-12490